![]() Look at the o-ring one last time, and again being careful not to stretch the o-ring, place the o-ring back in. Use an air-blower to blow off any hairs or dust from the groove, and relubricate the o-ring with a small amount of lube that your housing manufacturer suggests. Wash the o-ring off if it has sand on it that won't come off, or if it is really dirty. I usually wipe the o-rings off with my fingers, gently feeling for any dirt or particles. Gently wipe off the o-ring, being very careful not to stretch it. First remove the o-ring wipe out any dirt from the groove using a q-tip, with a paper towel underneath it. I use a q-tip and a high-quality paper towel to clean the groove the o-ring was in. Make sure you use the o-ring grease supplied by the manufacturer. Also perform this on your sync cord o-rings after every few dives.ĭo not over-lubricate the o-rings. I try to enter and exit the water with a cover on my dome port.Īfter every dive day, you should clean and relube the o-rings and grooves: Do this on the housing o-ring, the port o-ring, and the strobe battery compartment o-ring. Keep a neoprene cover over your dome port as much of the time as possible, to avoid getting the dome port scratched. Get your housing serviced every year with the appropriate authorities. I have heard many, many stories that start with "it flooded in the rinse tank". Afterwards, quickly towel-dry the housing.Īfter your dive, don’t leave your camera unattended in the rinse tank*. “Work” the buttons and controls for a few seconds while the camera is underwater, if possible. Soak it for longer if the salt water had a chance to dry. Soak the underwater case in fresh water for a few minutes after every salt water dive, if possible. When you exit the water, if you have a wide angle dome port on, train the crew to put your dome port cover on immediately to avoid scratches. Letting the sun hit your underwater case can cause condensation later when you dive, and can dry it out and cause salt crystals to form.Īlways keep 1 or 2 desiccants in the waterproof housing to prevent fogging upĪlways have your rig handed to you in the water, don't jump in with it When in the open, and especially in the hot sun, keep a wet towel over it. Never let your underwater housing sit in the sun, to prevent camera fogging.
0 Comments
Leave a Reply. |